Sun exposure. The transportation of Oxygen cylinders from China should be protected from direct sunlight when used in summer. Because the volume of the Oxygen Cylinders from China is limited, exposure to the sun will increase the temperature of the medium in the bottle, resulting in a sudden increase in the pressure in the bottle, putting the gas bottle in a dangerous state.

Some users did not take sunshade measures when transporting Oxygen Cylinders from China and exposed the cylinder to the sun when using it in summer. Especially in summer, the road temperature often reaches more than 40 degrees. If the gas cylinder itself is defective, overfilled, or collided with each other, an explosion accident may occur.
The safety distance is not enough. Oxygen Cylinder from China must be used 10 meters away from the open flame. It is strictly forbidden to store it in the same room as the acetylene bottle. However, many users ignore this requirement. There is a phenomenon that the distance between the oxygen cylinder and the welding point is less than 10 meters during the welding operation, and the gas cylinder and the acetylene cylinder are stored in the same room. Once the gas cylinder leaks and explodes in the event of an open flame, it will cause irreparable damage.
Brutal loading and unloading. In the transportation and use of Oxygen cylinders from China, the phenomenon of brutal loading and unloading is very common. For example, when transporting a short distance, the cylinder is pushed down with force and then rolled along the ground; Push down, and so on.
Overloaded. Oxygen Cylinder from China is overfilled due to a violation of operating procedures or operating errors during filling, which increases the pressure in the bottle and exceeds its allowable stress, and finally explodes due to excessive plastic deformation.
Through the above introduction and analysis of Precautions for Oxygen Cylinders from China, hope it helps you.